This section describes how specific components operate on the XD235 and XD1035.
On-Board LEDs
The four on-board LEDs have the following indicators:
| LED | Indication |
|---|---|
| Green power (Pwr) | Displays when the board is powered up and not in reset mode. Flashes during firmware update process. |
| Green file-system activity (Bsy) | Flashes any time there is file-system activity (on any storage device) |
| Blue (WiFi) | Flashes when the player is connecting to the wireless network. Displays solid when connected. |
| Red status (Err) | Flashes a certain number of times to indicate which error is occurring. The flash codes are described below:
|
On-Board Switch / SVC Button
The Service (SVC) button provides a dedicated GPIO button (GPIO12) for the OS. Pressing the SVC button pulls the pin low. Conversely, releasing the button pulls the pin high.
Reset Switch / GPIO Button
The Reset button is connected to the reset circuit. Pressing the Reset button will send an initial signal to the system software and holding the reset button low for approximately 4 seconds will cause a hard reset.
MicroSD Slot
The XD235 and XD1035 each have one MicroSD slot, which supports transfer modes up to UHS-1 DDR50 (50MB/s). There is no inherent limit on the storage capacity of microSD cards used with the player.
Wireless Module
The XD235 and XD1035 have a dual antenna connection which allows users to install a BrightSign wireless module. BrightSign modules are configured to work with 802.11.N or 802.11.AC access points.
This connection has a Bluetooth option.