...
ON THIS PAGE
| Expand |
|---|
...
| borderColor | #3D3D3D |
|---|---|
| bgColor | #F4F4F4 |
| titleColor | #3D3D3D |
| borderWidth | 0 |
| titleBGColor | #3D3D3D |
| borderStyle | solid |
| ||||
|
This section describes how specific components operate on the XD233 and XD1033.
On-Board LEDs
There are four on-board LEDs that indicate the following:
LED | Indication | |
|---|---|---|
Green power/update (Pwr) | Displays when the board is powered up and not in reset mode. Flashes during the firmware update process. | |
Green file-system activity (Bsy) | Flashes any time there is file-system activity (on any storage device) | |
Blue WiFi ( | Flashes when the player is connecting to the wireless network. Displays when connected. | |
Red status (Err) | Flashes a certain number of times to indicate which error is occurring. The flash codes are described below. | |
2 | Unspecified error | |
3 | Network recovery script is preparing to run on a device configured for network recovery. | |
4 | No upgrade file found. | |
5 | Failed to load kernel module. | |
6 | Board is not capable of running the current firmware version. | |
7 | A piece of on-board hardware is not working correctly. | |
8 | Problem related to the storage device (either the USB drive or microSD card) | |
9 | Problem related to the registry/NAND | |
10 | The autorun script encountered a load/run error. | |
11 | WiFi-related error | |
12 | Unable to find a bootable image. | |
On-Board Switch
The on-board switch is connected to the GPIO02GPIO12, which is pulled low when the service (SVC) button is pressed. Conversely, a pull-up on the button normally sets the GPIO02 GPIO12 to be pulled high.
Reset Switch/GPIO Button
The on-board switch is connected to the reset circuit. Pressing down the reset button will send an initial signal to the system software, and holding the reset button low for approximately 4 seconds will cause a hard reset.
microSD Slot
The XD233 and XD1033 have one microSD slot, which supports transfer modes up to UHS-1 DDR50 (50MB/s). There is no inherent limit on the storage capacity of microSD cards used with the player.
Wireless Module
The XD233 and XD1033 have an internal M.2 slot for installing a compatible wireless module. The M.2 wireless module connects via cables to two external, attachable wireless antennas.
SSD Module
The XD233 and XD1033 have XD1033 have an internal M-keyed M.2 slot for ATAPI SSD drives. See this page for all SSD specifications.