...
A single RJ45 jack is provided for connection to a local network conforming to IEEE 802.3 at up to 1000Mbps full duplex. 10base-T, 100base-TX and 1000base-T operation is supported.
HDMI Output
The HDMI®-out connector is used to send digital video and audio to HDMI-enabled sink devices. XC2055 has two HDMI ® outputs and the XC4055 has four HDMI outputs. One of the HDMI outputs on each device type is HDMI 2.1. CEC control is supported over each HDMI interface independently, and it can maintain the configured multiscreen layout if one of the HDMI outputs loses sync.
...
The GPIO connector functions are:
Pin | Primary | Secondary | Tertiary |
|---|---|---|---|
1 | GND |
|
|
2 | 3.3V PWR |
|
|
3 | Button0 | UART1_RXD |
|
4 | Button1 | I.R_IN |
|
5 | Button2 | SPDIF1_OUT |
|
6 | Button3 | PWM |
|
7 | GND |
|
|
8 | 3.3V PWR |
|
|
9 | Button4 | UART0_RXD | I2C_SCL |
10 | Button5 | UART0_TXD | I2C_SDA |
11 | Button6 | UART1_TXD |
|
12 | Button7 | I.R_OUT |
|
3.5mm IR Input/Output
The IR blaster can transmit and receive a variety of common Consumer-IR formats including NEC and RC5. RC5 encoding is also supported. The two transported bit values of the signal (0 and 1) are encoded using differing lengths of low-time IR pulses.
...
Tip: 3V@50mA
Ring: IR Input
Sleeve: IR Output
The sleeve is used as a ground during input operations. |
: Receive
Sleeve: Ground
3.5mm Serial
...