Versions Compared

Old Version 1

changes.mady.by.user BrightSign TechDocs

Saved on

compared with

New Version 2

changes.mady.by.user BrightSign TechDocs

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
This section describes how specific components operate on the XD235 LS425 and XD1035LS445.



On-Board

LEDs

Switch / SVC Button

The four on-board LEDs have the following indicators:

LEDIndicationGreen power (Pwr)Displays when the board is powered up and not in reset mode. Flashes during firmware update process.Green file-system activity (Bsy)Flashes any time there is file-system activity (on any storage device)Blue (WiFi)

Flashes when the player is connecting to the wireless network. Displays solid when connected.

Red status (Err)

Flashes a certain number of times to indicate which error is occurring. The flash codes are described below:

  • 2: Unspecified error
  • 3: Network recovery script is preparing to run on a device configured for network recovery
  • 4: No upgrade file found
  • 5: Failed to load kernel module
  • 6: Board is not capable of running the current firmware version
  • 7: A piece of on-board hardware is not working correctly
  • 8: Problem related to the storage device (either the USB drive or MicroSD card)
  • 9: Problem related to the registry/NAND
  • 10: The autorun script encountered a load/run error
  • 11: WiFi-related error
  • 12: Unable to find bootable image

On-Board Switch / SVC Button

The Service (SVC) button provides a dedicated GPIO button (GPIO12) for the OS. Pressing the SVC button pulls the pin low. Conversely, releasing the button pulls the pin switch is connected to the GPIO02, which is pulled low when the service (SVC) button is pressed. Conversely, a pull-up on the button normally sets the GPIO02 to be pulled high.


Reset Switch / GPIO Button

The Reset button is connected to the reset circuit. Pressing the Reset reset button will send an initial signal to the system software and holding the reset button low for approximately 4 four seconds will cause a hard reset.


MicroSD Slot

The XD235 The LS425 and XD1035 each LS445 have one MicroSD slot, which supports transfer modes up to UHS-1 DDR50 (50MB/s). There is no inherent limit on the storage capacity of microSD cards used with the player.


Wireless Module

The XD235 and XD1035 have a dual antenna connection which allows users to install a BrightSign wireless module. BrightSign modules are configured to work with 802.11.N or 802.11.AC access points.This connection has a Bluetooth optionoptional WiFi module also has Bluetooth functionality.