...
Conditional Targets allow you to change the behavior of an event transition depending on the value of a User Variable. You can set multiple Conditional Targets for a single event, and you can specify new commands to occur when the Conditional Target is met. With this feature, you can change the behavior of a presentation based on a wide array of interactive and networked conditions.
...
You can add commands to interactive events or to states. If you add a command to an interactive event, the command will be performed when that event occurs. If you want to add a command to a state, you will need to choose between an Entry Command (executed upon entering the state) or an Exit Command (executed upon leaving the state). Some commands (such as Switch Presentation) can only be added to interactive events.
Set Panel Output
This section has an accompanying tutorial video:
| Widget Connector | ||||||
|---|---|---|---|---|---|---|
|
Configures the LED output of an attached USB device (BP200, BP900, or BLC400)
...
- Send Zone Message: Triggers a Zone Message event with the same command parameter as the Send Zone Message command.
- UDP: Sends a message to a networked device using the UDP protocol. Go to Presentation Settings > Interactive > Networking to specify the destination address and port for UDP messages.
- Send IR Remote: Sends a command via the 3.5mm IR Out port.
- Send IR Remote (Pronto): Sends a command using Pronto Hex Code (PHC) via the 3.5mm IR Out por.
- Serial string (EOL): Sends the specified string to the specified serial port. This command adds a carriage return at the end of the string.
- Serial string (no EOL): Sends the specified string to the specified serial port. This command does not add a carriage return at the end of the string.
- Serial byte: Sends the specified byte to the specified serial port. The byte must be entered in decimal format (0-255).
- Serial bytes (comma separated): Sends the specified bytes to the specified serial port in comma-separated format.
...
- Send Plugin Message: Sends the specified string to a custom script plugin attached to the presentation. Use the dropdown menu to select a desired script plugin. Please see the Parsers and Plugins tech note for more information on creating custom scripts that can receive plugin messages.
...
Changes the state of GPIO buttons that are configured for output.
- On: Turns on the specified GPIO button.
- Off: Turns off the specified GPIO button.
- Set State: Allows you to turn multiple GPIO buttons on or off. The buttons are specified as bits in an integer value; see the documentation for roControlPort.SetWholeState() for an example.
...
- Pause: Pauses presentation playback for a specified number of milliseconds.
- Reboot: Reboots the BrightSign player.
- Set Variable: Sets a new value for the specified User Variable.
- Increment Variable: Increases the value of the specified User Variable by 1.
- Decrement Variable: Decreases the value of the specified User Variable by 1.
...
- Reset Variable: Resets the specified User Variable to its current default value.
- Reset Variables: Resets all User Variables to their current default values and all Media Counters to zero.
- Switch to Presentation: Switches to a different presentation. Before using this command, you must add additional presentation(s) by navigating to Presentation Settings > Support Content > Switch Presentation. The following settings must be identical for both presentations: BrightSign Model, Connector Type, Screen Resolution, Monitor Orientation, and Monitor Overscan.
- Specify Presentation: Choose the presentation to switch to from the dropdown list.
- Specify via user variable: Choose the User Variable that will determine which presentation to switch to. The value of the User Variable must be identical to the name given to the target presentation in the Switch Presentations tab.
- Update Data Feed: Refreshes the contents of the specified Data Feed.
- Resize Zone: Repositions and/or resizes the specified zone. Select the zone you wish to modify. Then enter an X and Y coordinate (corresponding to the top-left corner of the zone), as well as W and H (width and height) values for the zone.
- Hide Zone: Hides the specified zone from view.
- Show Zone: Shows the specified zone if it is hidden.
...